For those of us who are inexperienced and unfamiliar with the Honda HRU 216 lawn mower and its various mechanical aspects, it can be disconcerting and troubling when we first hear the clicking of our lawn mower gearbox as we’re going about mowing lawns. While it may appear as a daunting problem that might lead us to think that our lawn mower is broken, the actual issue is not serious at all and is very common, not just in the Honda lawn mower, but in other brands of lawn mowers that use the same 3 speed gearbox.
What causes the clicking sound is when the clutch cable is not fully engaging the gearbox into the drive position, this is what creates the clicking sound, and this is why the lawn mower is no longer self propelling properly.
The reason this is happening is because the clutch cable has stretched with use, so now when we push in the drive bail, the gearbox is not being properly engaged, we hear the clicking and the mower might not move at all.
Once we start hearing the noise and experiencing the drive issue, we must repair the problem as soon as possible, otherwise we really do risk damaging the gearbox.
Repairing The Clutch Cable On A Honda HRU 216
The first option is to adjust the clutch cable, this is easily done with 2 x 10mm spanners, the adjustment nuts are on the middle cable at the control box on the mower handles.
We want to adjust the nuts just a little bit so that the clicking stops and the drive works properly again. First try adjusting a few millimetres, tighten up the nuts and test the drive, repeat again if the clicking continues.
A new lawn mower, or new clutch cable will allow us to do this several times before the cable itself needs to be replaced.
Eventually over time and after those few adjustments we will run out of adjustment room on the screw thread, this is when the clutch cable will need to be replaced.
Clutch cables are not that expensive, about $50, and are relatively easily replaced.
There are Youtube videos which might be of help, but after you’ve done it once, you can do it again and again in just minutes. So for anyone who might be cautious about trying to do this themselves, it really is quite easy, and it looks more daunting than it actually is.
The Gearbox Arm On A Honda HRU 216
There is one other aspect to gearbox clicking and drive issues related to the clutch cable on these lawn mowers, and other lawn mower brands that use the same gearbox.
There is a little arm on the gearbox, onto which the clutch cable joins.
This little arm can bend over time, and because of this, this arm too will need to be replaced occasionally as well. How often does it need replacement compared to the clutch cable? Well if we adjust the clutch cable several times over a long period of time, until eventually the cable needs replacement, then it might be a good practice to change the arm at the same time.
With this method we want to replace the arm when we replace the clutch cable.
This makes sense to ensure the downtimes of our mowers are reduced as much as possible and their reliability remains as high as possible. Why have two unexpected breakdowns that also requires the back end of the mower to be pulled apart for repair two times, when we can do both things at once for only a few minutes of more time.
While the bail on our lawn mower handle goes in a long way when we push it, the actual corresponding movement on the gearbox only equates to millimetres, so just a small bend in this arm and it can throw off the engagement of the gearbox entirely when we push the bail, which in turn would once again give us this same clicking sound and the gearbox not engaging properly and perhaps not driving at all.
These are the two factors which cause a Honda HRU 216 lawn mower gearbox to make clicking sounds.
A stretched clutch cable, and / or a bent gearbox arm.
I’ll detail how to replace both in another article.

all articles and images are © copyright
thelawnmowingman.com
