The Lawn Mowing Man

how to start your own lawn mowing business

 

LAWN MOWING WORK

how to undertake all types of lawn mowing work in a lawn mowing business

This practical tutorial will cover the mowing of a small lawn with a cylinder mower. The relevant factors with this lawn is that it is one lawn section of other lawns at the property, however all other lawns are mowed with a rotary lawn mower. Also this lawn is surrounded on two sides by retaining walls, and on two sides by level paths.

With this lawn the retaining walls will be the overriding factor that determines how I will mow this particular lawn.

Blade Edging

Blade edging is done first, there is no reason that it should be left until a later stage.

Line Trimming

Line trimming around the retaining walls is required to be done next, because if I didn’t and if I left the line trimming until after lawn mowing, it would leave noticeable mess on the client’s lawn.

There is also another reason why I line  trim the retaining wall first, which I will explain shortly.

The cylinder lawn mower can go right up to the edge of the level paving. Normally with level paths I would trim those tiny few remaining bits of grass after lawn mowing. However because I must use the line trimmer on the retaining wall first, I will also do a very gentle light trim around the level paths too, otherwise I would be double handling the line trimmer and wasting time.

Cylinder Mower Height

I adjust the cutting height for this lawn to about 18mm. The lawn is Couch with some Buffalo mixed in. The area is partial shade which is good for the Buffalo, but is not suitable to a Couch lawn. Buffalo always likes to be cut at a higher height than fine leafed grasses. With these two factors of the Buffalo wanting a slightly higher cut, and Couch growing in partial shade which will require to be cut higher in order to increase photosynthesis in partial shade, this then determines my choice of mowing height.

Ideally Couch in partial shade like this and Buffalo too, should both be mowed at higher heights than this, however as this is a cylinder mowed lawn, I just can’t get those heights while making the lawn look good while Couch is still heavily present and dominant. Once the Buffalo overtakes and dominates the Couch, then I can increase cutting heights to around 25mm with the cylinder lawn mower.

First Cylinder Lawn Mowing

You’ll notice in the corner where the two retaining walls meet that there is no way I can get the cylinder mower with its bucket anywhere near that corner, so I have to first mow that corner with the cylinder mower but without the catcher attached. With this job however, and because the lawn is so small I will mow all along the retaining walls without the bucket attached, taking the mower right into that corner. I do one pass in each direction, which takes less than two minutes.

Completed Cylinder Lawn Mowing

mowing along the retaining walls first - without a catcher
 

Paths Blown Clean

The lawn edger makes a mess on this job, as did the cylinder mower when I mowed along the retaining wall without the bucket, as does the line trimmer. so I blow the paths clean before the rest of the lawn mowing is undertaken.

Second Cylinder Lawn Mowing

I then put the bucket onto the cylinder mower and go around the retaining walls once more to pick up the lawn clippings that I made earlier, as well as all that fine leaf material too.

I then do a perimeter cut along the pathways, and I double width cut along one retaining wall to give me enough turning room for the lawn mower. Then I go up and down and finish mowing the lawn in a few minutes.

Completed Cylinder Lawn Mowing

the completed cylinder lawn mowing job
 

Paths Blown Clean

Once again, as with other jobs, the only thing left on these paths is a little dust and maybe a few odd clippings here and there, which requires 10 seconds with the blower to finish cleaning up.

 
Start A Lawn Mowing Business In Australia
 
how to start a lawn mowing business in australia
all articles and images are © copyright
thelawnmowingman.com
 
 

how to start a lawn mowing business in australia